Select your vehicle

              Your vehicle selection:
              Close
              (0) items
              You have no items in your shopping cart.
              Shop By Category
                settings
                filter_list
                Manufacturer: TEIN

                TEIN SW100-01175 - Straight Coil Springs (Pair)

                $114.00
                $120.00
                Standardized Spring Straight W10
                SKU: TEI-SW100-01175
                Availability: Out of Stock - on backorder and will be dispatched once in stock.
                Fitment:
                Universal Fit - Not Vehicle Specificeditedit...
                Fitment Notes:

                Straight Type Springs

                • We use SWOSC-KV silicon chrome metal (JIS standard) to pursue the maximum quality of high tension and endurance for all standardized springs
                • Stable quality, endurance, and high performance is maintained by special procedure (cooling formation)
                • The straight type springs are measured by inner diameter and, specified spring seat is required
                • The outer diameter changes with alignment

                Taper Type Springs

                • These are standardized springs which have been developed to adopt with original upper mounts for original double wishbone and multi – link suspension system
                • Ideal for N1 and other vehicles whose upper mounts cannot be replaced under regulations
                • By eliminating the upper spring seat, we have achieved low cost and adequate bump stroke
                • It eliminates the damage to upper mount and other noise by maintaining same force input positions as original products
                • As it is tapered, spring stroke can be maintained better than the straight type with same spring coefficient and length

                Helper Spring

                • By setting 2 springs in a series, variable spring rate can be achieved
                • It gives unlimited setting range with wide winding point weight set ups
                • The A spring is a series twin spring, and the B spring can be selected from straight type with I.D.70mm or tapered type springs. A variable spring is achieved through changing over from original spring rate to B spring rate.
                • The spacer spring seat is necessary for installation with the A spring

                ALL TEIN STANDARDIZED SPRINGS ARE SOLD AND PRICED ‘PER SPRING’ – FOR A COMPLETE SET OF 4 YOU NEED TO ORDER QUANTITY 4

                Straight Type Springs

                • We use SWOSC-KV silicon chrome metal (JIS standard) to pursue the maximum quality of high tension and endurance for all standardized springs
                • Stable quality, endurance, and high performance is maintained by special procedure (cooling formation)
                • The straight type springs are measured by inner diameter and, specified spring seat is required
                • The outer diameter changes with alignment

                Taper Type Springs

                • These are standardized springs which have been developed to adopt with original upper mounts for original double wishbone and multi – link suspension system
                • Ideal for N1 and other vehicles whose upper mounts cannot be replaced under regulations
                • By eliminating the upper spring seat, we have achieved low cost and adequate bump stroke
                • It eliminates the damage to upper mount and other noise by maintaining same force input positions as original products
                • As it is tapered, spring stroke can be maintained better than the straight type with same spring coefficient and length

                Helper Spring

                • By setting 2 springs in a series, variable spring rate can be achieved
                • It gives unlimited setting range with wide winding point weight set ups
                • The A spring is a series twin spring, and the B spring can be selected from straight type with I.D.70mm or tapered type springs. A variable spring is achieved through changing over from original spring rate to B spring rate.
                • The spacer spring seat is necessary for installation with the A spring

                ALL TEIN STANDARDIZED SPRINGS ARE SOLD AND PRICED ‘PER SPRING’ – FOR A COMPLETE SET OF 4 YOU NEED TO ORDER QUANTITY 4

                Products specifications
                Fitment Universal Fit